UPDATE: Since many of you have asked about a weight measure for the 10 cups of tomatoes, as I've been canning the salsa the last few days, I've done a little experimenting/research. Basically, I've found it varies GREATLY depending on variety. When I used SIX pounds of garden tomatoes + Roma (the paste tomatoes probably only made up about 1/3 of the total), after taking the skins off, lightly crushing, and draining, the yield of tomatoes to use in this recipe was about 2 1/2 cups. When I used TWO pounds of only Roma/paste tomatoes, after taking the skins off, lightly crushing, and draining, the yield of tomatoes to use was a little over one cup. I tend to err on the side of over draining the tomatoes, if anything, so that makes a difference as well. For me, because I usually use paste tomatoes in this recipe, I would plan on around 18-20 pounds (give or take) of Roma/paste tomatoes to get the 10 cups for this recipe...and even more if using tomatoes with a higher water/lower flesh content.
Not many paragraphs into the introduction, the working title warped into something more along the lines of “Mexican Food: A Love Affair!”. When, a few more paragraphs into the original article, I realized that one post was simply not enough to detail my admiration for Mexican food culture: I threw the question up on my Instagram: “Should I do an entire beginner’s guide to Mexican Food?”
i have found adding a small amount of cucumber (just the skin and flesh, not the watery seedy part) to fresh salsa really intensifies/perks up the “fresh flavour” with the cilantro! have never gone back now that i have tried it…learned this tip in Puerto Morelos this year from a local….just add it to the blending stage in a recipe so the flavour is evenly distributed
Why this meticulous approach to chili picking? Well, for the simple reason that it adds a stunning complexity to the salsa and provides the best possible product: a salsa roja that is at one time bright, fresh, fruity and acidic and at the same time rich, deep and complex in flavor with a noticeable, warming but not overpowering heat profile. This, in my own humble words, make it the PERFECT all-round salsa for every application including dipping, slathering, spreading, cooking or mixing.
Use your jar lifter to place the jars into the canner leaving space in between them. Once jars are all in canner, adjust the water level so it is at least one inch above the jar tops. Add more boiling water if needed so the water level is at least one inch above the jar tops. When adding water, use the hot water from the small pot your lids were in. Pour the water around the jars and not directly onto them.
Water bath canning involves submerging the jars in boiling water for a set period of processing time. It is suitable for high acid foods. Pressure canning (not pressure cooking) involves processing the jars in a sealed pressure canner at elevated temperature and pressure. You must can all low acid foods. You can can high acid foods, but most people just water bath can them. Some folks prefer dealing with the steam over dealing with a big pot of boiling water, which is why I give both options for this recipe. It is heavy on tomatoes and also has added vinegar, which should keep the pH below 4.6.
The best way to peel tomatoes is to get a large pot of water boiling and then place the tomatoes in the boiling water for 30 seconds. (Some suggest placing them in ice water next, but that isn’t necessary for this recipe) When you remove the tomatoes from the boiling water their skins will start to split (you may need to assist them by piercing them with the tip of a knife) and they can then be easily peeled.
Explain, please, about tomato peels. My tomatoes are quartered or smaller, still with peels. What are the safety consequences? Also, BTW, thanks for the update on steam canners. I’ve used one for years (and for you canning newcomers, they’re cheap at Goodwill, etc.), with the reluctant, hard-won approval of a food science pro, only on condition of his anonomity (because of that research issue). Glad to know approval is now official!
When processing time is complete, turn off heat and allow the canner to cool down and settle for about 10 minutes. Spread a kitchen towel on the counter; remove the cover by tilting lid away from you so that steam does not burn your face. Use a jar lifter to lift the jars from canner and place on the towel. Allow the jars to cool for 12 to 24-hours. You should hear the satisfactory “ping” of the jar lids sealing.
A note on chili varieties: Mexican cuisine uses a wide variety of chilies with different names and characteristics – most of them essential to the final result of the dish they are used in. You should be able to rather easily acquire the chilies described in this (and future) post cheaply online. If you’re having trouble finding these chilies, I suggest you stick to a mix of Ancho (a mild, fruity variety) and Chipotle (a hotter, smoked variety). Both are readily available and this blend will still lend you quite a bit of the complexity.
Chris Munn, it's so nice to meet someone with Peruvian connections! What a treat that your wife has introduced you to so many Peruvian favorites. I've found that Peruvians are very proud of their cuisine and every region has their own specialties. I'm glad you found this salsa recipe. It's simple to prepare and my favorite salsa. Thanks for coming by and leaving a meaningful comment.